Table of Contents
Advertisement
3.7 Software Version
To display the EL-2648's software version:
1.
In Programming mode, scroll using the
appears on the display
2.
Press SELECT.
3.8 Restoring Default Settings
Restoring default settings enables you to erase all the programming modifications that you have made
to the stand-alone receiver. This will also delete the transmitter register.
To reset default settings:
1.
In Programming mode, scroll using the
appears on the display.
Press SELECT; DEFAULT, OK? appears on the display.
2.
3.
Press SELECT to restore all settings to default, or press
4 Operation
This chapter deals with the receiver's behavior in normal operation mode when the tamper switch is
closed.
4.1 System Displays
During normal operation, the EL-2648 displays events as they happen. These events are displayed
until the condition is restored. The following table explains each event display and the events that
cause them to appear:
#
DISPLAY
ALARM
1
XXXXXXXX
KFXX
2
ARM/DISARM
AC LOSS
3
XXXXXXXX
ANTENNA
4
TROUBLE
BATT LOW
5
ZONE X/KFXX
6
JAMMING
7
OUT SYNC
ZONE X/KFXX
RECEIVER
8
TAMPER
SUPERVSN
9
XXXXXXXX
TAMPER
10
XXXXXXXX
TROUBLE
11
XXXXXXXX
Note: These messages are only displayed when the LCD is configured as "Enabled".
When multiple events occur simultaneously, each event message is displayed for three seconds.
Panic alarms are not displayed on the receiver's LCD.
and
CAUSED BY
An Alarm from the indicated zone.
An arm/disarm command from a keyfob.
An AC loss transmission from the indicated zone.
Damage to the antenna (antenna cut or removed).
* Only relevant to versions with antenna supervision
A low battery condition from the indicated transmitter.
A jamming condition detected by the receiver.
A transmission that is out of synchronization. If this message appears, the
displayed transmitter is out of synchronization with the receiver. In some cases,
this may indicate that an attempt to "grab" the transmission has occurred - i.e. a
previous transmission has been recorded and sent by somebody trying to violate
the system.
Opening the EL-2648's tamper switch.
Supervision loss from the indicated zone.
A Tamper transmission from the indicated zone.
A Trouble transmission from the indicated zone.
Table 3: System Displays
-12-
navigation keys until MAIN, SW VER.
navigation keys until MAIN, DEFAULT
or
and
together to cancel.
Advertisement
Table of Contents
