Table of Contents
Advertisement
Thread the four cables into the lock nuts.
3.
Do not insert the lock nuts into the openings to
avoid damaging the appliance's limit switch.
To protect against scratches, position a spacer on
4.
the appliance and place the frame cover on top of
it.
Thread the cables through the openings of the
5.
frame cover.
Undo the strain relief on the cable on the appliance
6.
and pull out the cable.
Remove the strain relief fitted at the factory.
7.
Put the strain relief to one side.
ATTENTION! There is a risk of damage to the appli-
8.
ance if the cable is coiled up.
Always secure the cable firmly using the strain
▶
relief so that it does not coil up fully in the appli-
ance.
Thread the cable on the appliance through the
opening in the frame cover and use the strain relief
supplied to secure it.
Thread the four cables into the cable tensioner and
9.
apply equal tension.
Do not shorten the cables.
Readjust the cables. To do this, relieve the load on
10.
the appliance, loosen the cable tensioner and push
the cables up.
Installation instructions en
19
Advertisement
Table of Contents
