Control Panel - Hisense RD-30WC4SAW Instruction Manual

Control panel

Temperature C ontrol S lider
chamber
The temperature control slider is used to
adjust the refrigerator
temeperature,the slide on the thermostat is
used to balance the distribution of air flow
volume of each compartment. With the slider
turns down,which will cause more air flow in
refri-gerator and less air flow in freezer ,so the
refrigerator will be cool
operating use,keep the slider in the centre
normal position. You should not need to adjust
the temperature control dial if the slider is kept
at the normal setting.
Turning on the appliance and setting
the thermostat
You switch on you appliance by
connecting it to you mains sup-ply and
setting the thermostat,the thermostat
control knob is located at the top .Wind
path parts in refrigerator.The thermostat
automatically regulates the temperature
interior refrigerator chamber and freezer
chamber ,depending on what number you
have turned the thermostat control knob
to:
1.If the ambient temperature is higher
temperature(in summer),please set the
control knob at"5
2. If the ambient temperature is lower
temperature(in winter),please set the
c o n t r o l k n o b a t " 1 o r 2 " p o s i t i n g .
3. please set the control knob at"3 or
4"positing in usual condition.
Important!
Normally we advise you select setting of 2 or
3 or 4, if you want the temperature warmer
or colder please turn the knob to lower or
higher setting accordingly.When you turn the
knob to lower which can lead to the more
energy efficiency. Otherwise, it would result
the energy-consuming.
in r efrigerator
and freezer
faster.For normal
6 or 7"positing.
Knob
If it gets too cold in the chilled chamber with
the switch on "Cold", just turn the switch
back to"Mid",if the temperature gets higher
in the chilled chamber with the switch
on"Colder",just turn the switch to"Mid".
Important!
High ambient temperatures (e.g. on hot
summer days) and a cold setting on the
temperature re-gulator (position 6 to 7)
can cause the compressor to run
continuously or even non-stop!Reason:
when the ambient temperature is high, the
compressor must run continuously to
maintain the low temperature in the
appliance..
C hanging the l ight bulb
WARNINGS!!!
Before removing the light bulb,cither the
refrigerator or disconnect the electricity
leading into the refrigerator at the main
power supply. Failure to do so could result
inelectrical shockor personal injury.
1.Use the cross screw driver to take the
screws out.
2.Remove the light cover .
3.Light Bulb-screw out the bulb according to
the direction shown in the picture
4.Replace with a 10 watt-refrigerator bulb
that is of the same shape and size.
5.Replace the light cover.
EN
5