Advertisement
Quick Links
TONNEAU INSTALLATION GUIDE
Warranty, Care & Maintenance
Model 2110 Ford Sport Trac 2007
30
EASY AS 1-2-3!
NORMAL INSTALLATION TIME
MINUTES
FORM # IG2110
Modified January 2007
For Warranty Issues, Contact Undercover Directly
(866) 900-8800 www.undercoverinfo.com
Advertisement
Subscribe to Our Youtube Channel
Related Manuals for UnderCover 2110
Summary of Contents for UnderCover 2110
- Page 1 TONNEAU INSTALLATION GUIDE Warranty, Care & Maintenance Model 2110 Ford Sport Trac 2007 EASY AS 1-2-3! NORMAL INSTALLATION TIME MINUTES FORM # IG2110 Modified January 2007 For Warranty Issues, Contact Undercover Directly (866) 900-8800 www.undercoverinfo.com...
-
Page 2: Pre-Installation Notes
Be sure to use only cleaners, waxes, etc., which are labeled ‘Safe for Plastics’. Make sure that chemicals or substances, which are not labeled ‘safe for plastics’, do not come in contact with your Undercover. Failure to do so could cause discoloration and/or structural damage to your Undercover and will void your warranty. - Page 3 Note: If your Tonneau has already been installed, skip to Page 9 for removal and reinstall instructions. Off your truck and on your wall in less than one minute! FORM # IG2110 (866) 900-8800 www.undercoverinfo.com Modified January 2007 UnderCover makes tonneaus for most makes and models of trucks.
- Page 4 Page 3 TONNEAU INSTALLATION GUIDE Model 2110 Ford Sport Trac 2007 EASY AS 1-2-3 UNDERCOVER INSTALLATION INSTRUCTIONS FACT: Undercover is the lightest hardshell tonneau in the industry. Only 58-pounds for full size trucks. Installing your Ford Sport Trac hardware is very simple and easy to do. The Sport Trac comes with the mounting holes already in place.
- Page 5 Page 4 TONNEAU INSTALLATION GUIDE Model 2110 Ford Sport Trac 2007 UNDERCOVER INSTALLATION INSTRUCTIONS MINUTES FORM # IG2110 (866) 900-8800 www.undercoverinfo.com Modified January 2007...
- Page 6 DOWN. DOING SO CAN SHEAR-OFF THE BALL STUD AND CAUSE SERIOUS DIFFICULTY CORRECTING. Once your UnderCover is installed you will be able to lift the cover up and clip on the strut and mount it to the ball stud. See Page 6, Picture C.
- Page 7 Page 6 TONNEAU INSTALLATION GUIDE Model 2110 Ford Sport Trac 2007 UNDERCOVER INSTALLATION INSTRUCTIONS MINUTES Ball Stud that goes in place of Torx Bolt Torx Bit that comes with your truck. Torx Bolt FORM # IG2110 (866) 900-8800 www.undercoverinfo.com Modified January 2007...
- Page 8 Page 7 TONNEAU INSTALLATION GUIDE Model 2110 Ford Sport Trac 2007 EASY AS 1-2-3 UNDERCOVER INSTALLATION INSTRUCTIONS FACT: Undercover’s ABS-Composite material makes it the strongest and most durable tonneau on the market. Like the rear-mounting bracket installing the front bracket is much the same. Remove the plastic studs exposing the 3 preset bolt holes located at the front of the bed.
- Page 9 Page 8 TONNEAU INSTALLATION GUIDE Model 2110 Ford Sport Trac 2007 UNDERCOVER INSTALLATION INSTRUCTIONS MINUTES Figure 1 FRONT BRACKET MOUNTING POSTS Figure 2 FRONT BRACKET MOUNTED TO BED RAIL MOUNTING POST HINGE SLOTS 4-BAR HINGE PRE-MOUNTED TO COVER TWIST KNOB FORM # IG2110 (866) 900-8800 www.undercoverinfo.com...
- Page 10 Page 9 TONNEAU INSTALLATION GUIDE Model 2110 Ford Sport Trac 2007 UNDERCOVER INSTALLATION INSTRUCTIONS Slots on 4 bar hinge should be sitting on mounting post ready to MINUTES be pushed into position. Unsecured Push 4-bar hinge slots into mounting post securing hinge system.
- Page 11 Page 10 TONNEAU INSTALLATION GUIDE Model 2110 Ford Sport Trac 2007 TEST FIT COVER PROPERLY BEFORE FINAL SECURING OF KNOBS AND CLAMPS. With your cover installed, including Hydraulic Struts (see Step 4) leave your tailgate open and cover closed. Check locks to see if they line-up properly and the strike cams slide under lock plate without any resistance. If there is resistance, you can adjust lock plate with 10mm wrench.
- Page 12 In less than one minute, you can both take on and off the Undercover tonneau. Fastest removal system in the industry. Install hydraulic struts making sure LARGE end of strut is attached to the tonneau, and SMALL or rod end is attached to the ball stud on rear bracket Page 12, Figure 7, Picture A.
- Page 13 Page 12 TONNEAU INSTALLATION GUIDE Model 2110 Ford Sport Trac 2007 UNDERCOVER INSTALLATION INSTRUCTIONS Figure 7 MINUTES HYDRAULIC STRUT (LARGE END) ATTACHES TO TONNEAU HYDRAULIC STRUT TRUCK BED RAIL (ROD END) REAR BRACKET NOTE: Sport Trac stud attaches as shown in Picture A.
- Page 14 Page 13 TONNEAU INSTALLATION GUIDE Model 2110 Ford Sport Trac 2007 Congratulations! Your 30-minute installation job is now complete. Now, in less than one minute, you will be able to put on and take off your tonneau cover. UNDERCOVER REMOVAL & REINSTALATION INSTRUCTIONS...
- Page 15 Page 14 TONNEAU INSTALLATION GUIDE Model 2110 Ford Sport Trac 2007 UNDERCOVER WALL HANGING INSTRUCTIONS Prior to removing the tonneau, STEP 1 mount the two J-Hooks provided on 32” the garage wall. The hooks must have a minimum height from the floor of 84”, and be 32”...
- Page 16 Page 15 TONNEAU INSTALLATION GUIDE Model 2110 Ford Sport Trac 2007 UNDERCOVER SERIAL NUMBER LOCATION THANK YOU! Congratulations! You’ve just installed the fastest-selling, highest-quality tonneau in the industry. Thank you very much for your purchase of UnderCover! Steve Brallier President E.D.
Need help?
Do you have a question about the 2110 and is the answer not in the manual?
Questions and answers