Kurzweil MP15 User Manual page 22

The Program Change parameter determines whether or not MIDI Program Change messages
are sent for Setups. You can set this parameter to either On or Off.
1) Press the [Function] button.
2) Press the [Func -] or [Func +] buttons to step through the parameter list.
3) You can change the parameter value when "ProgChg:On" is on the LCD.
4) Pressing the [Next] or [Previous] button will select a new 'Program Change' value.
5) Pressing both value buttons simultaneously will set this parameter to 'On'.
The SysEx ID parameter determines the ID number for the unit if you are using more than one
device with the same MIDI manufacturer ID number. You can set this parameter to any number
from 0 to 127.
Unless you have multiple MP15 pianos receiving SysEx messages from a single source, you will
not need to change the SysEx ID from the default setting of 0.
If you do have multiple MP15 pianos receiving SysEx messages from a single source, make sure
each MP15 has a different SysEx ID. This will allow you to direct SysEx messages to the appro-
priate MP15 by specifying which unit with the SysEx ID byte that's included with every SysEx.
To have the unit respond to SysEx messages regardless of the SysEx ID, set SysEx to 127.
Performing a Hard Reset will delete all user-recorded songs and will restore all parameters to
default values. This action cannot be undone.
The "Hard Reset ?" dialogue allows you to restore factory defaults to the piano. Pressing the
[Next] button in this dialogue will change the display to "Confirm ?". Pressing the [Next] button
in the "Confirm ?" dialogue will result in a hard reset - pressing the [Previous] in the
"Confirm ?" dialogue will recall the "Hard Reset ?" dialogue.
To exit the Hard Reset dialogue, simply select another parameter using the [Func +],[Func -]
buttons, or enter another mode using the [Function] button.
8
2 2
Functions
P r o g C h g : O n
S y s e x I D : 0
H a r d R e s e t ?