Table of Contents
Advertisement
AXIS P3235 Network Camera Series
Setup
2. Adjust the alarm level according to your needs.
Create a rule:
1. Go to Settings > System > Events and add a rule.
2. Type a name for the rule.
3. In the list of conditions, under Audio, select Audio Detection.
4. In the list of actions, under Recordings, select Record video.
5. Select the stream profile where audio has been turned on.
6. Set the prebuffer time to 5 seconds.
7. Set the postbuffer time to 60 seconds.
8. In the list of storage options, select SD card.
9. Click Save.
Use audio to deter intruders
This example explains how to connect a speaker to the camera and set it up to play a warning message when the camera detects
motion in a restricted area.
Required hardware
•
Active speaker with built-in amplifier and connecting wires
NO
NOTICE
NO
TICE
TICE
Make sure the camera is disconnected from power before making the connections. Reconnect to power after connecting the
wires.
Physical connection
1. Connect the audio wire to the speaker from the line out pin of the audio connector.
2. Connect the grounding wire to the speaker from the GND pin of the audio connector.
Add audio clip to the camera
1. Go to Settings > Audio > Output and click
2. Click Upload new clip.
3. Browse to locate your audio clip and click Done.
To trigger the camera to play the audio clip when it detects motion, create a rule in the camera's webpage.
Detect tampering with input signal
This example explains how to trigger an alarm when the input signal has been cut or short-circuited. For more information about the
I/O connector, see page 25.
1. Go to Settings > System > I/O Ports and turn on Supervised I/O.
Create a rule:
1. Go to Settings > System > Events and add a rule.
.
18
Advertisement
Table of Contents
