Table of Contents
Advertisement
Off
Incorrect Modbus connection to the card
Master is not polling
Incorrect baud rate setting
Incorrect byte format
Verify that the Low signal is
connected to terminal N and the
High signal is connected to
terminal P
Verify that the master (PLC or
PC) is polling the inverter.
Verify that the baud rate (I/O47) is
set to match the baud rate of the
inverter.
The inverter communicates using
8 data bits, 1 stop bit and no
parity bits. Verify that the master
is set to the same.
modbus-rtu iS5 manual.doc
7
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the MODBUS-RTU and is the answer not in the manual?