Serial Port Configuration; Device Assignments; Device Configurations - Wegener UNITY4600 User Manual

Professional digital media receiver/decoder
Table of Contents

Advertisement

Installation
Connector
Designation
ASI IN
RF IN
* LNB DC power may be locked to OFF by network.
Table 2.2 below lists the Unity 4600 front-panel connectors, their types and pinout
information.
Connector
Designation
Video Monitor
Audio Monitor

2.4 Serial Port Configuration

Device
The Unity 4600 has one external serial port. A "device" must be assigned once to the serial
assignments
port, but no "device" may be assigned more than once. In addition, more than one device
may be assigned at one time but only one device which accepts input may be assigned. (If
multiple devices are assigned to the serial port, the port's settings are controlled by the
device with higher priority according to the list below.) Device port assignment and device
configuration (see below) may be controlled only from the unit front panel and the network
may disable this capability. The possible devices are:
1.
2.
3.
4.
5.
Device
When a serial port configuration command is received, the specified configuration is
immediately stored for the specified device (e.g. for the "Terminal" device). If a serial port is
configurations
currently assigned another device, then its output buffer is immediately flushed and the port
re-configured. Communication is fixed at 1 start, 1 stop, and 8 data bits, with no hardware
handshaking. No provision for software handshaking is made in this Release. The serial
port's behavior for each of its device types is described in the following table:
22
Type
BNC Jack
<plugged>
Table 2.2: Front-panel Connectors
Type
BNC jack
¼" stereo phone jack
Terminal
Modem ("modem" being remote terminal via modem)
®
Local COMPEL
Auxiliary Data
Printer (including COMPEL
Table 2.3: Device Configurations
Device
Serial Port Behavior (Italics are Programmable, Bold are Fixed)
Terminal
Configured to 19.2k, N, 8, 1. The unit responds to the terminal commands as
described in
3.4 Operation from Local/Remote Terminal
Modem
Configured to B, P, 8, 1. The unit responds to the commands as described in
3.4 Operation from Local/Remote Terminal
800032-01 Rev. G
Pin
DVB-ASI Input
Not used
Pin
Composite Video monitor
Stereo audio headphone monitor,
selectable between audio ports 1 or 2
®
e-mail and reports)
Signal Name
Signal Name
on page 59.
on page 59.
www.wegener.com

Advertisement

Table of Contents
loading

Table of Contents