Weed Eater Twist 'N Edge 545186757 Instruction Manual page 13

USER REPLACEABLE SERVICE PARTS
REPLACEMENT PART
Spool with 0.065" Trimmer Line
Spool Cap
Assist Handle
Wheel
Battery (authorized distributor replacement item)
Charger GPE182- -120120- -1
Wall Mount Bracket
WARNING:
Perform the following
steps after each use.
S Stop the unit and place in wall bracket for
storage and battery charging.
S Carry the unit with motor stopped.
TROUBLESHOOTING TABLE
WARNING:
Always stop unit before performing all of the recommended remedies be-
low except remedies that require unit to be operating. Keep hands and fingers away from
the trigger switch to avoid accidental starting.
TROUBLE
CAUSE
Trimmer head 1. Crowding trimmer line
stops under a against material being
load or does not cut.
turn when switch 2. Battery needs charging.
is pressed. 3. Debris stopping head.
Line does not 1. Line improperly routed
advance, line is in head.
too short, or 2. Line improperly
trimmer vibrates. wound into spool.
3. Incorrect line size
4. Not enough line
outside of head.
5. Manual line feed not
working.
6. Dirt buildup on unit.
Excessive noise 1. Motor has not reached
when unit is run- full speed before use.
ning. 2. Too much line has been
released from the spool.
3. Line limiter pin missing
from shield.
Line releases
1. Line improperly
continuously. routed in head.
2. Spool damaged.
Line usage is
1. Line improperly routed
excessive.
in head.
2. Line size is incorrect.
3. Crowding line against
material being cut.
4. Spool worn or damaged.
Wheel stops 1. Dirt or debris buildup
on wheel or in groove.
turning.
SERVICE PART NUMBER
545124406
545124417
545124407
545124409
545124412
525802301
545124411
STORAGE
S Store unit in a high, dry place out of the
reach of children.
S Store unit with all guards in place. Position
unit so that any sharp object cannot acci-
dentally cause injury.
REMEDY
1. Allow tip of line to do the cutting.
2. Charge battery.
3. Remove debris.
1. Check line routing.
2. Rewind line tightly and evenly.
3. Use only 0.065 in. (1.65 mm) dia. line.
4. Remove spool cap and spool. Manually
feed line. Reinstall cap and spool. See
Automatic Line Feed System section.
5. Rewind line tightly and evenly. Check
that line is in correct section of spool.
6. Clean unit.
1. Allow the motor to reach full speed
before use.
2. Rewind line tightly and evenly. See
Automatic Line Feed System section.
3. Contact your authorized service dealer.
1. Check line routing.
2. Replace spool.
1. Check line routing.
2. Replace spool.
3. Cut with tip of line fully extended.
4. Replace spool.
1. Clean wheel and groove on motor
housing (see Maintenance section).
13