Page 1
Veuillez lire le manuel de l’utilisateur et bien respecter tous les avertissements et toutes les instructions de sécurité. Bien lire les instructions avant d’assembler l’outil. Tout défaut de le faire pourrait entraîner des blessures graves. WEED EATER 7349 Statesville Road Charlotte, NC 28269 115254026 ®...
SAFETY RULES WARNING: When using electric gar- dening appliances, basic safety precautions must always be followed to reduce the risk of fire, electric shock, and serious injury. Read and follow all instructions. SAFETY INFORMATION ON THE UNIT This power unit can be dangerous! Operator is responsible for following the warnings and instructions in this manual and on the unit.
Never use wire, rope, string, etc. S Use specified trimmer spool. Make sure spool is properly installed and all parts are securely fastened. S Use only WEED EATER replacement parts and accessories as recommended. CUTTING SAFETY WARNING: Inspect area to be cut.
ASSEMBLY WARNING: If received assembled, review all assembly steps to ensure your unit is properly assembled and all fasteners are secure. TUBE ASSEMBLY Upper Locking Sleeve Assembly Wire protector Wires Lower Locking Sleeve Assembly 1. Remove the wire protector from the tubes and discard.
Edge Guide Shield 2. Insert the shield onto the motor housing. Ensure the cutting head remains free to rotate and the line is not caught between the shield and the motor housing (see following illustration). 3. Twist the shield as illustrated until the hole in the shield aligns with the hole in the housings.
Use only a voltage supply as specified on your unit. SELECT AN EXTENSION CORD Extension Cord Gauge Chart Length of Cord Gauge 18 Gauge 25 Ft. (7.5 m) 16 Gauge 50 Ft. (15 m) 16 Gauge 100 Ft. (30 m) Extension cords are available for this unit.
Page 7
WARNING: Use only 0.065 inch (1.65 mm) diameter line. Other sizes of line will not ad- vance properly and will result in improper cutting head function or can cause serious injury. Do not use other materials such as wire, string, rope, etc.
5. Clean entire surface of hub and spool. 6. Replace with a pre- -wound spool or cut a length of 26 feet (8 meters) of 0.065″ (1.65 mm) diameter WEED EATER brand line. Use of heavier lines could overload and damage unit.
USER REPLACEABLE SERVICE PARTS REPLACEMENT PART Spool with 0.065″ Trimmer Line t s i t l o M6x1 Knob Spool cap Bolt STORAGE WARNING: Perform the following steps after each use. • Stop the unit and disconnect the power source when not in use. •...
WEED EATER brand electric or cordless product within two (2) years from the original date of purchase. If your WEED EATER brand electric or cordless product should fail within the limited warranty period, you may return it in complete condition,...