Electrical Connection - Samsung NV31T4551 Series Installation Manual

Install_NV31T4551SS_AA_DG68-01266A-00_EN.indd 11
4. Lower the oven door to the fully open
position. If the oven door does not open
to a full 90°, repeat steps 1 through 3.
5. Locate the oven door hinge locks in the
corners of the oven door, and rotate the
hinge locks toward the oven cavity to
the locked position.
See Step 1 (illustration A) in the
"Remove Oven Door(s)" section for
proper locked position.
6. Close the oven door.
7. When the hinges are properly installed
and the door closed, there should be
an even gap between the door and the
control panel. If one side of the oven
door is hanging lower than the other,
the hinge on that side is not properly
installed.
8. Connect Wire Harness.

Electrical connection

WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Use 8 gauge solid copper wire.
Electrically ground oven.
Failure to follow these instructions can result in death, fire, or electrical shock.
Electrical Connection Options Chart
If your home has:
4-wire
4-Wire Cable from Home Power Supply
1 / "
2
(1.3 cm)
3-wire
3-Wire Cable from Home Power Supply
/ "
1
2
(1.3 cm)
NOTE
If the power connection is plugged in improperly, "bAd LinE" appears on the
display.
Reconnect the power connection properly, and the message disappears.
Go to section:
English 11
2020-02-27 PM 3:58:36