Adam AE 403 Series Service Manual page 22

7.2.8 Reserve enough wire length inside the indicator and tightly screw the nut outside
the load cell waterproof end cap.
7.2.9 Put the rubber sealing ring on the front indicator, then put the rear cover back. Fit
the screws removed in section 7.2.1 and screw them tight. Make sure the rubber sealing
ring is flat and all the screws must go through the sealing ring correctly. Using a torque
wrench tight it to 1N.m of torque. When tightening the screws, tighten screws from
alternate sides, until all the screws are tightened. Do NOT tighten screws working from
one screw to the screw next and so on After tightening it, the clearance between front
cover and rear surroundings should be consistent
© Adam Equipment Company 2019
Fit the nut and screw it
tight. When the connector
attaching the case starts
turning, stop applying force.
Screw x12
Rear cover
Rubber sealing ring
Front cover