When the display shows
stable symbol "~" appears again, press
If the linearity calibration is successfully completed, the indicator will restart.
4.1.12
"" Tare display mode
Press the
[
] key to enter this parameter, the display will show
key to change parameter, there are and parameters available to select,
press
[
] to accept the selected parameter. automatically clears the tare when
the reading goes to zero
the tare.
4.1.13
"" Set dot or comma as decimal
Press the
[
] key to enter this parameter, the display will show
key to change parameter, there are
press
[
] to accept the selected parameter.
4.1.14
"" Calibration control
Press the
[
] key to enter this parameter, the display will show
key to change parameter, there are
select, press
[
] to accept the selected parameter.
indicator is calibrated, which can then be used for traceability
occur when a jumper is fitted.
Note: if you select and accept it, you can only access the supervisor, dealer and
user menus, once you install the calibration jumper on the PCB.
4.1.15
"" Reset all parameters to factory settings
Press the
[
] key to enter this parameter, the display will show
to change parameter, there are and parameters available to select, press
to accept the selected parameter.
Note if you select and accept it, all parameters will be reset to the original factory
settings and the indicator will restart.
Details of these menus are given in the User manual section 12.
© Adam Equipment Company 2019
put specified weight on the weighing platform. When
[
] to accept.
shows the tare value, and only allows, manual clearing of
and
parameters available to select,
and parameters available to
increments each time the
calibration can only
Use or
Use or
Use or
Use or key
[
]