MTX 350359 User Manual page 5

4. Align the laser using the bubble chamber. The aligned level must have the vial at the center of the bubble
chamber. Adjustment is made by loosening three adjusting screws. When the level is aligned, the sound
signal will stop.
ATTENTION!
Laser wouldn't work if the tilt angle will be more than 2,5˚.
5. On control panel there are three buttons - "H», «V» and «Outdoor». On a bright light, click «Outdoor» - will
increase the brightness of the ray.
By clicking the button "H" turns on a horizontal laser and will start to show the horizontal line. Pressing the
button again turns off the horizontal level.
By clicking the button «V»:
• once - turns on the first vertical laser;
• twice - turns on the second and third vertical laser at 45 ° angle relative to the first;
• three times – turns on the fourth ray, turn on all the lasers;
• four times - all the lasers are turned off.
Also, after you press the button «V» on the lower part of the level- laser level switches on, which projects a
point on the lower surface.
6. Rotate the device for pointing a laser ray on the target. Micrometer screws used for fine-tuning.
7. Turn the switch counterclockwise (against the clock) to switch off the laser.
SELF LEVELING LASER
V
Outdoor
H
5