Prime Fresh Quick Mode Q&A; Nanoe Q&A - Panasonic NR-F681GT-XA Operating Instructions Manual

Does not get cold at all
Does not get cold enough
Frost and dew
The food is frozen
Prime Fresh Quick Mode does
not start. (The select room lamp
(LED) does not turn to blue)
Prime Fresh Quick Mode lamp is
lit continuously.
Much food was put in, but Prime
Fresh Quick Mode does not
operate.
A small amount of food was put
in, but Prime Fresh Quick Mode
operates.
Much food was put in, but nanoe
lamp does not flash.
nanoe lamp does not turn on.
A small amount of food was put in,
but nanoe lamp flashes.
●
Is it indicated in the notice indicator area of the control panel? (P. 21)
●
When you use the refrigerator for the first time, from 4 to 24 hours or
even more are required until the refrigerator begins to cool.
●
Has the power supply failed?
●
Is the temperature control set to " 1 " ? → Set to " 2 ". (P. 8)
●
Is a food item blocking the cold air outlet? (P. 2)
●
Is the refrigerator subject to direct sunlight or are there any heating
devices in its vicinity? (P. 6)
●
Is sufficient spaces secured around the refrigerator? (P. 6)
●
Is a hot item stored, doors opened frequently or too much food stored?
Freezer compartment/Refrigerator compartment
●
This condition occurs when humidity is high, door was kept open for a
long time or opened frequently.
●
Is a door slightly open due to a commercially available tube stand or the
like being caught in it or too much food being put in the refrigerator?
Outside of the refrigerator
●
May occur when using [FRESH FREEZING] in succession when there is high humidity.
→ S imply wipe with a piece of dry cloth.
●
Has the temperature control been set to " 3 " ? → Set it to " 2 ". (P. 8)
●
Is the ambient temperature 5 °C or below? → Set it to " 1 ". (P. 8)
●
Did you put food with high water content near the cold air outlet in the
refrigerator (P. 2) or in the prime fresh/chilled select room?
Prime Fresh Quick Mode Q&A
●
When the prime fresh/chilled select room is set to [CHILLED], Prime
Fresh Quick Mode does not operate. (P. 8, P. 13)
●
When [QUICK MODE] button is pressed and the setting of Prime Fresh
Quick Mode is off, Prime Fresh Quick Mode does not operate. (P. 13)
●
While Prime Fresh Quick Mode is set, the lamp is lit continuously. (P. 13)
It is not linked to the operation of the select room lamp (LED) during
Prime Fresh Quick Mode.
●
When temperature of the food stored is low, refrigerator judges that Prime
Fresh Quick Mode is not necessary.
●
When the temperature in the refrigerator or freezer compartment is high,
Prime Fresh Quick Mode does not operate. When the temperature in
compartment is cooled down and stable, Prime Fresh Quick Mode may
start.
●
When the temperature of food stored is high or when the flap of the case has
been opened for long time, refrigerator may judge that Prime Fresh Quick Mode is
necessary.
nanoe Q&A
●
Storage sensor detects only the storage amount in the refrigerator
compartment. (P. 8)
●
When the brightness of nanoe lamp is set to "OFF", the lamp does not
turn on. Set the brightness of lamp to "Dim" or "Bright". (P. 23)
●
When food is stored near the storage sensor (on the glass tray or in the
door shelf), the lamp may flash.
●
While nanoe is operating in powerful mode, the lamp flashes.
(After powerful mode, nanoe operation is switched to normal mode and
the lamp does not flash.)
Appendix
en-25