Panasonic NR-F681GT-XA Operating Instructions Manual page 18

Appendix
Trays / 1-2 convenient shelf (made of glass)
■
Tray (Upper shelf in the refrigerator)
Unhook the protrusion at the back of the tray and pull it.
■
Tray (2nd shelf from the top in the refrigerator)
Lift up the back of the tray and pull it forward.
Once the protrusions of the tray are unhooked from
the rails, tilt the tray and remove it.
Attention
●
The partition shelf is not removable. Do not remove the partition shelf when you clean it.
●
Trays, the 1-2 convenient shelf and the partition shelf are made of glass and heavy.
Please handle them with care so that they do not fall and cause any damage or injury.
For attaching trays, hold them with the protrusion side down and firmly insert.
Case (Prime Fresh/Chilled select room)
■
Removing
Attention
●
Please take out the bottle shelf first when removing the case. (Otherwise, the bottle shelf may be damaged.)
●
Please take out the case first when removing the aluminum plate.
If the aluminum plate is washed with water, please reattach it after draining water and wiping the waterdrop
remaining on it.
●
The contact sections of the case and the door have been coated with lubricant. Do not wipe it off.
→ C onsult your dealer if you wipe off.
Door shelf/Bottle shelf
■
Removing
Tap the bottom of the small shelves upward
or slide alternately the left and right of the
big shelves upward, and raise them slowly.
(Tightly attached)
en-18
Protrusion
Tray
Tray
Protrusion
Rail
Pull out the case as far as
possible. With lifting up the
front, pull it out at an angle
with holding the flap above
the case.
The aluminum plate
can be removed.
Slide the shelves
upward.
■
Unhook the protrusion at the front of the 1-2
convenient shelf and pull it.
Rear part
Front part
■
Rear part of the 1-2 convenient shelf
Remove the front part (refer to the upper illustration).
Slightly lift the rear part and pull it.
■
Re-installing
■
Re-installing
Set each shelf horizontally, with the
mark [>PS<] on the right, and push it
down to its proper position.
Once every 3 months
Fit the rear part of the 1-2
convenient shelf so that the
hole on it is towards you.
Once every 3 months
With holding up the flap, lift
the back of the case and
install it along the rails inside.
Once every 3 months