Electrical Connection - Electrolux EWF 128500 W User Manual

2. The other end of the inlet hose which
connects to the appliance can be
turned as showed in the picture.
Do not place the inlet hose down-
wards. Angle the hose to the left or
right depending on the position of your
water tap. Set the hose correctly by
loosening the ring nut. After positioning
the inlet hose, be sure to tighten the
ring nut again to prevent leaks.
35°
The inlet hose must not be lengthened.
If it is too short and you do not wish to
move the tap, you will have to pur-
chase a new, longer hose specially de-
signed for this type of use.
WATER DRAINAGE
The end of the drain hose can be posi-
tioned in three ways.
The drain hose may be extended to a maximum of 4 metres. An additional drain hose
and joining piece is available from your local Service Centre.

ELECTRICAL CONNECTION

Any electrical work required to in-
stall this appliance must be carried
out by certified Service Centre.
Information on the electrical connection is
given on the rating plate on the inner edge
of the appliance door.
• Hooked over the edge of a sink using
the plastic hose guide supplied with the
machine. In this case, make sure the end
cannot come unhooked when the ma-
chine is emptying. This could be done by
tying it to the tap with a piece of string or
attaching it to the wall.
45°
• In a sink drain pipe branch. This
branch must be above the trap so that
the bend is at least 60 cm above the
ground.
• Directly into a drain pipe at a height of
not less than 60 cm and not more than
90 cm. The end of the drain hose must
always be ventilated, i.e. the inside diam-
eter of the drain pipe must be larger than
the outside diameter of the drain hose.
The drain hose must not be kinked.
Check that your domestic electrical installa-
tion can take the maximum load required,
also taking into account any other applian-
ces in use.
Connect the machine to an earthed
socket.
electrolux 25