Transport; Storage; Care And Service; Troubleshooting Guide - Kärcher MT 36 Bp Original Instructions Manual

Removing accessories
1. Loosen the clamping screw.
2. Pull out the lock.
3. Remove the shaft of the accessory.

Transport

CAUTION
Failure to observe the weight
Risk of injury and damage
Be aware of the weight of the device during transporta-
tion.
1. Remove the battery pack (see Chapter Removing
the battery pack).
2. Secure the device against slipping and tipping over
when transporting in vehicles.

Storage

Clean the device before storing (see Chapter Cleaning
the device).
CAUTION
Failure to observe the weight
Risk of injury and damage
Malfunctions often have simple causes that you can
remedy yourself using the following overview. When in
doubt, or in the case of malfunctions not mentioned
here, please contact your authorised Customer Service.
Fault
The device does not start
up
The device stops during
operation
Problems when mount-
ing the shaft compo-
nents

Warranty

The warranty conditions issued by our relevant sales
company apply in all countries. We shall remedy possi-
ble malfunctions on your appliance within the warranty
period free of cost, provided that a material or manufac-
turing defect is the cause. In a warranty case, please
contact your dealer (with the purchase receipt) or the
next authorised customer service site.
(See overleaf for the address)

Troubleshooting guide

Cause
Battery pack is not inserted correctly.
Battery pack is empty
Battery pack is defective.
The battery has overheated
The connection points are dirty.
Be aware of the weight of the device during storage.
1. Remove the battery pack (see Chapter Removing
the battery pack).
2. Remove the accessories if necessary (see chapter
Removing accessories).
3. Store the device in a dry, well ventilated location.
Keep away from corrosive substances such as gar-
den chemicals and defrosting salt. Do not store the
device outdoors.

Care and service

WARNING
Uncontrolled startup with mounted accessories
Incision injuries
Remove the battery from the device before all work on
the device.
 Switch the device off and remove the battery before
performing any work on the device.
Cleaning the device
1. Clean the device with a soft, dry cloth.
Illustration I
As the battery pack ages, even if it is looked after, its ca-
pacity reduces such that the full run time will no longer
be reached when fully charged. This does not indicate a
defect.
Rectification
 Push the battery pack into the mounting
until it latches into place.
 Charge the battery pack.
 Replace the battery pack.
 Stop working and allow the battery to cool
down to normal battery temperature.
 Clean the shaft ends of adhering dirt.
 Only place the device on clean surfaces.

Technical data

Device performance data
Working voltage of the battery
Maximum speed
Dimensions and weights
Length x width x height
Weight (with battery pack)
Subject to technical modifications.
English
V 36
/min 7800 ±
10%
mm 940 x
197 x
188
kg 2,6
21