Table of Contents
Advertisement
MAINTENANCE
Main Burner Flame Pattern
The Weber Gas Barbecue burners have been factory set
for the correct air and gas mixture. The correct flame
pattern is shown in Figure 6.
Burner inside
cooking box
If the flames do not appear to be uniform the length of the
burner tube, follow the burner cleaning procedures.
Main Burner Cleaning Procedure
Turn off the gas supply. Remove the manifold. Look
inside each burner with a flashlight. Figure 7.
Clean the inside of the burners with a wire (a straightened
out coat hanger will work). Figure 8. Check and clean the
air shutter opening at the ends of the burners. Check and
clean the valve orifices at the base of the valves. Use a
brass bristle brush to clean outside of burners. This is to
make sure all the burner ports are fully open.
CAUTION: Do not enlarge the burner ports when
cleaning.
Tips occasionally yellowish
Light blue
Dark blue
Figure 6
Figure 7
Figure 8
Replacing the Burners
1 . Your Weber Gas Barbecue must be OFF and cool.
2 . Turn OFF gas at source.
3 . Disconnect regulator.
4 . To remove control panel refer to "Remove the control
panel and the front panel" in the Step-By-Step Guide.
5 . Remove splash guards.
6 . Remove cooking grates.
7 . Remove Flavorizer bars.
8. Remove the manifold by unsnapping the clips at the
right and left front of the cooking box. Figure 9.
Summit 600
10
Summit 400
Figure 9
Hide quick links:
Advertisement
Table of Contents
