Page 2
tABLe oF CoNteNtS System Information Safety Information operation Release Steps Storage of Steps Adjust Leg Extension SolidStep 3.0 Assembly ® SolidStep 3.0 Components ® System Information The SolidStep® 3.0 is a trailer entry step assembly mounted to the side of any trailer, providing an ease of entry, regardless of level ground.
Page 3
operation Release Steps Disengage transport lock (Fig. 1). Firmly grasp and pull out the vertically stored SolidStep® and firmly rest it on the ground. Adjust leg extensions as needed, see Leg Extension Adjustment section. Fig. 1 transport Lock Storage of Steps Retract leg extensions, if desired.
Page 4
SOLIDSTEP 3.0 ASSEMBLY ® STEPS Step Identification top Step Full Step Lock Assembly Plunger Bolt Rev: 07.30.2018 Contact us: Lippert Components Inc. - www.lci1.com/support - Phone: (574) 537-8900 - Email: customerservice@lci1.com Page 4 of 8...
Page 5
Rivet Nut - 20 Threads 1/4" 1/2" 254080 Button Head Screw -20 x 1/4" 3/4" 118230 Hex Head Self Tapping Screw -14 x Rev: 07.30.2018 Contact us: Lippert Components Inc. - www.lci1.com/support - Phone: (574) 537-8900 - Email: customerservice@lci1.com Page 5 of 8...
Page 6
Top Step Extrusion - 24" Long (Current) Note: The top step of SolidStep® 3.0 was previously comprised of N and O, but has been replaced with P. Rev: 07.30.2018 Contact us: Lippert Components Inc. - www.lci1.com/support - Phone: (574) 537-8900 - Email: customerservice@lci1.com...
Page 7
328736 Nylon Spacer - 1" Outer Diameter 675819 Vinyl Cap for Latch Flanges 645118 Vinyl Handle Cover for Latch Lever Rev: 07.30.2018 Contact us: Lippert Components Inc. - www.lci1.com/support - Phone: (574) 537-8900 - Email: customerservice@lci1.com Page 7 of 8...
Page 8
The contents of this manual are proprietary and copyright protected by Lippert Components, Inc. (“LCI”). LCI prohibits the copying or dissemination of portions of this manual unless prior written consent from an authorized LCI representative has been provided. Any unauthorized use shall void any applicable warranty. ...
Need help?
Do you have a question about the SolidStep 3.0 and is the answer not in the manual?
Questions and answers