Table of Contents
Advertisement
DAB Operation
If the unit is connected to the mains power and then
switched on from standby for the first time, the unit
will automatically enter into the DAB mode and
perform auto scan function. The display will show
"Scan Services Quick Scan" then will start to show
the frequencies and the station numbers being
GB
scanned.
Once the scan has finished, the unit will tune to the
first alphanumerically found station and the service
name will be displayed on the upper segment of
the display. To explore the found stations press the
buttons. When you find a station that you
would like to listen to, press the SELECT button.
If no stations are found after auto scan, the display will show
"Service N/A".
DAB Auto Scan
The auto scan will search for the entire DAB Band III channels. After the scan has finished,
the first alphanumerically found station will be automatically tuned.
Auto scan will not replace the DAB stations in the memory.
If you want to remove all the previously scanned stations, a
system reset is required.
To activate Quick scan, press the SCAN button
1.
and the display will show "Scan Services Quick
Scan". This may take 30 seconds to 1 minute,
depending on the number of stations found.
To activate Full scan, press and hold the SCAN
2.
button and the display will show "Scan Services
Full Scan". This may take up to 3 minutes,
depending on the number of stations found.
3.
All the stations that have been found will be
stored automatically. To explore and select
listening to the found stations, press the
buttons. When you find a station that you would
like to listen to, press the SELECT button.
Press and hold the SELECT button to turn Auto Enter On/Off. When Auto Enter is on, after
pressing the
14
buttons to our desired station, the unit will automatically tune to this station
Advertisement
Table of Contents
