Maintenance; Cleaning And Maintenance; Description Of Controls; Technical Details - Apache Euro Operating Instructions Manual

ground. Unscrew the oil plug screw (using an SW 7 allen screw). Oil level: to the lower edge of filler opening. Oil type: gearbox oil SAE 80. Gear box oil change
(only when engine/gear box is hot) As a general rule the oil should be changed after every 60 work hours (oil viscosity SAE 80) To change oil: a) Remove
the screw cap. b) Tilt the unit to pour the oil out. c) Add the new oil. Oil is at correct level when it reaches the bottom edge of the filler hole. d) Replace filler screw
cap.
I I I I I

MAINTENANCE

Regularly check the level of the oil in the worm gear unit. Change oil after every 60 hours of use. Type of oil: Gearbox oil SAE 80
- ca. 0,25 l. Adjust the throttle cable. Replacing the cultivator blade: Knock out the roll pin. Remove the blade. Attention: When replacing the blade,
check that it is correctly positioned. The ground edges of the blades must be in the same turning direction as the axle shaft.
I I I I I

CLEANING AND MAINTENANCE

plug removed! Cleaning: Clean the machine each time after use. Warning! Risk of injury from blades - always wear protective gloves. Keep all
nuts, bolts and screws tight to ensure the equipment is in safe working condition. Never store the machine with fuel in the tank inside a building where fumes
can reach an open flame or spark and however allow the engine to cool before storing indoors. To reduce the fire hazard, keep the engine, silencer, battery
compartment and fuel storage area free of grass, leaves and excessive grease.
I I I I I

DESCRIPTION OF CONTROLS

g) Brake rod h) Cultivator blade i) Spring pin
I I I I I

TECHNICAL DETAILS

Fuel tank contents approx. 1.0 L. - Please consult the relative instruction manuel for other technical information and details about the engine.
I I I I I
NOISE AND VIBRATION LEVEL
with EN and ISO 5349. Level detected = 6 m/s
I I I I I
AVAILABLE ACCESSORIES
seeding furrows. The cultivatorcouples to the cultivator shaft with a split pin once the standard (36 cm) cultivator has been removed by knocking out the pin.
The trencher is fixed to the machine in place of the plough coulter and is locked in place with a safety clip. It is severely forbidden to use attachments other than
those listed above. When fitting the cultivator blades, check that they are correctly positioned. The ground edges of the blades must be in the same turning
direction as the axle shaft.
8
Cleaning and maintenance work should only be carried out with engine switched off and spark
(Fig. 1) a) Clutch lever b) Handlebar c) Throttle lever d) Engine e) Transportation wheel f) Handle retainer
Working width 35 mm - max. speed of blade -120 min
Noise level when working in compliance with EN 709 L A e q = 79,1 dB (A). Handlebar vibration in compliance
2
16 cm rotary cultivator for easy cultivation in narrow rows. Trencher or furrow opener ideal for making shallow
-1 - Mass approx. 25 kg. - Fuel 4 stroke petrol