Correct Assembly Of The Bowden Rod, Engine Fuel Regulation; Operating Instructions; Adjusting The Working Depth; Work Function - Apache Euro Operating Instructions Manual

chassis using the wing nut. The wheel must be removed when hoeing.
I I I I I
Fit the brake rod (g) and secure with the spring pin (i).
I I I I I
Screw the handle retainer to the console
I I I I I
Put the upper handle into the shaft head
18 mm; 2 locking nuts M 6. Lock with the M 8 x 30 wingnut. (Fig. 2)
I I I I I
To switch on the cultivator blade, activate the clutch lever.
I I I I I
To switch off the cultivator blade, release the clutch lever.
I I I I I

Correct assembly of the Bowden rod, engine fuel regulation

engine fuel lever. Now lightly clamp the jacketed end of the rod. Set the fuel lever on the handlebar to the start position then set the fuel lever on the engine to
the start position, right up to the stop point. Following this, definitively fix the jacketed end of the rod.Take care to prevent the rod from bending during the
assembly phase. If the fuel lever fails to move freely, lubricate the rod with a few drops of oil and wait a few minutes to allow the oil to penetrate the casing. Now
operate the fuel lever again.
I I I I I
Any fine adjustment to the throttle cable is made via the adjusting screw which is situated under the fuel tank
I I I I I
OPERATING INSTRUCTIONS Adjusting the height of the upper handle
adjusted according to the size of the person and the relevant working conditions. By tilting the handle console within the area of the oblong holes, the height
of the upper handle can be adjusted (10). The normal height setting should be hip height.
I I I I I

ADJUSTING THE WORKING DEPTH

rod at the required working depth and secure back in position with the spring pin. Brake rod in lowest position: shallow working depth - Brake rod in
uppermost position: deep working depth
I I I I I

WORK FUNCTION

With the engine running, position the blades on the soil: hold the machine firmly and press the brake rod into the ground. Activate
the clutch lever on the handle. The cultivator blades will now dig into the earth. If you slightly raise the cultivator by the handles, the machine will go forwards.
when working, the brake rod should always be in the earth. For transporting the machine in a car or on a trailer etc. the upper handles can be folded down. To
do this, unscrew the butterfly screw on the shaft head. Unhook the throttle cable from the lug. Push the shaft head upwards and fold the upper handles over
forwards.
I I I I I
CHECKING BEFORE PUTTING INTO OPERATION
(Fig. 1)
(Fig. 2) 4 screws M 6 x 16 - 2 washers diameter 6 - 24 mm (fit these alongside the oblong holes).
and screw down with the handle retainer: 2 screws M 6 x 20; 2 washers diameter 6, outer diameter
The working depth can be set from ca. 5 - 12 cm. using the brake rod. Remove the plug. Set the brake
Check the oil level in the worm drive unit. Stand the cultivator on even
(Fig. 3) Insert the opposite end of the Bowden rod down into the
(Fig. 2) The height of the upper handle should be
7