Zanussi ZDT26050FA User Manual page 6

Programme
P5
Delicate
P4
4)
Quick 30 Min
1) The pressure and the temperature of the water, the variations of the mains supply, the options and the
quantity of dishes can change the values.
2) With this programme, you have the most efficient use of water and energy consumption for crockery
and cutlery with normal soil. This is the standard programme for test institutes.
3) The appliance senses the degree of soil and the quantity of items in the baskets . It automatically ad-
justs the temperature and the quantity of water, the energy consumption and the programme duration.
4) With this programme, you can wash a half-load dishwasher with fresh soil. It gives good washing results
in a short time.
SETTINGS
PROGRAMME SELECTION MODE
In the programme selection mode, it is possible to
set a washing programme and to enter the user
mode to change the appliance settings.
To enter the programme selection mode:
Press on/off button.
• The display shows the number of the
programme ECONOMY .
• After a few seconds the display shows the
programme duration.
If the control panel does not indicate that the
appliance is in the programme selection mode,
follow the RESET procedure.
RESET PROCEDURE
Use RESET to:
• Cancel a currently running programme.
• Stop the countdown of Delay option.
• Bring the appliance back to the programme
selection mode.
To RESET:
Press and hold RESET until the control panel
indicates the appliance is in the programme
selection mode.
6
Degree of soil
Programme phases
Type of load
• Normal or •
light soil •
• Delicate •
crockery and
glassware
• Fresh soil •
• Crockery •
and cutlery
Duration
(min)
Wash 45 °C 12 - 14
Rinses
Dry
Wash 60 °C
Rinses
USER MODE
Settings available in the user mode:
• The level of the water softener according to the
water hardness.
• Activation or deactivation of the rinse aid empty
notification.
• The level of rinse aid according to the required
dosage.
• Activation or deactivation of the acoustic signal
indicating the end of a programme.
• Activation or deactivation of AirDry.
Before entering the user mode, make sure the
appliance is in the programme selection mode.
To enter the user mode:
Press and hold simultaneously
least 3 seconds.
The indicators:
flashing.
As the appliance stores the saved settings, there is
no need to configure it before every cycle.
ADJUSTING THE WATER SOFTENER
Make sure the appliance is in user mode.
Consumption values
1)
Energy
(kWh)
0.7 - 0.9
10 0.9
and
, , , and
Water
(l)
82 - 92
30
for at
start