Weber 5000 Series Owner's Manual page 21

Insert one end of the hinge rod into the hole in the
frame. Figure 28 (a).
Insert the other end into the hole in the swing table end
bracket. Figure 28 (b). Hold the end bracket at an angle so
the lower tab is inside the frame tube. Push the bracket into
the frame. Check to see that the lower tab of the bracket is
hooked in the slot in the frame. Figure 28 (c).
To fully seat the bracket, you may have to tap it lightly with a
hammer.
WARNING: If swing table end bracket is in any
way cracked or damaged, do not use swing table.
Call our Customer Service Center to order a new
part.
WARNING: The load limit for the swing table is
30 pounds.
(b)
View from rear
of barbecue
(c)
Slot in frame
(view from below)
(a)
Hinge rod
Figure 28
Position slide bar assembly on the outside of the wheel
frame. Put a nylon washer on each 1 3/4 inch screw,
insert screws through frame and slide bar assembly and
add nylon washers and hex nuts. Tighten nuts using a
screwdriver and pliers. Figure 29.
View from front
of barbecue
To lower table: Pull support rod up to disengage slide
lock and lower table. To raise table, lift table up and
engage slide in locked position. Figure 30.
Unlocked position
21
Notch
Slide bar
Wheel frame
Figure 29
Support rod
Slide
Locked position
Figure 30