Weber 5000 Series Owner's Manual page 17

Step 14
Install tank panel assembly
You will need: tank panel assembly.
Slide the side burner back. Insert the tabs into the slots
in the frame brace at the wheel legs. (Make sure the
side burner hose is to the front of the barbecue.)
Figure 17 (a). Slide up until the notch at the bottom of
the tank panel fits over the cross brace. Figure 17 (b).
Frame brace
Side burner
hose
Figure 17
Cross brace
Slot in frame brace
(a)
Tabs on tank panel
(b)
Step 15
Install right end panel
You will need: right end panel (Number 3), 1/4-20 x 1 1/2
inch bolt, 1/4-20 hex nut, two nylon washers and a 7/16
inch wrench.
Set the right end panel in place with the flange at the top
facing away from the barbecue, and the bottom flange
under the frame brace. Figure 18.
Make sure the gas supply hose is on the outside of the
panel. Put washer on bolt and insert bolt through both
panels and frame brace. Add washer and hex nut and
tighten. Figure 18.
Side burner hose
Figure 18
17
Hose and regulator