Handy Hints - Black & Decker KA110 Manual

DUST EXTRACTION SYSTEM
Most of the dust from the work surface is collected in
the dustbag. The extraction fan of your sander draws
the dust from the surface through the holes in the
sanding platen. The dust then passes through the fan
shroud to the dustbag. You can connect your sander to
a vacuum cleaner for dust extraction purposes.
An adapter is available from Black & Decker as a part.
REMOVING AND EMPTYING THE DUSTBAG
Disconnect the plug from the electricity supply.
the sander. A click is heard when the dustbag is
correctly fitted. Do not wash the dustbag, Empty the
dustbag every 10 minutes.

HANDY HINTS

• Always sand with the grain of the wood. If you sand
across the grain you may leave swirl marks.
• Your sander can be used in two different ways,
either in detail mode for accessing corners, or in
orbital mode for flush sanding up against edges.
• Replace worn sandpaper.
• Use the correct grade of sandpaper.
Low grit coarse sandpaper gives a high material
removal rate, with a coarse finish.
High grit fine sandpaper gives a low material
removal rate, with a finer finish.
As a general rule, start with the low grit paper and
finish with the higher grit.
TOOL CARE
Do not apply excessive pressure when you use your
sander. This can cause your sander to overheat. If your
sander becomes too hot, operate it off-load for 2 minutes.
Keep the cooling vents on the motor housing clear.
To clean your sander proceed as follows:
Disconnect the plug from the electricity supply.
Use a clean dry paintbrush to clear vents and ducts.
Clean the housing using a clean damp cloth (do not use
solvents, petrol or turpentine).
EC DECLARATION OF CONFORMITY
We declare that units:
KA110, KA110E conform to 89/392/EEC, 89/336/EEC,
EN55014, 73/23/EEC, EN55104, EN50144
A weighted sound pressure 81dB (A)
Hold your sander Hand/arm weighted vibration <2.5m/s
150W, 10500/min
vertically with the
dustbag facing
downwards. Pull the
bag gently holding the
grips on the side of the
Brian Cooke - Director of Engineering
dustbag. Empty the
Black & Decker Ltd, Spennymoor, County Durham
dustbag and replace on DL16 6JG United Kingdom
The Black & Decker policy is one of continuous
improvement to our product and as such we reserve
the right to change the product specification without
prior notice.
Always hold your
sander with two hands.
ENGLISH
2
23