Weber PLATINUM SERIES 2 2200 NG User Manual page 9

INSTALL WORK SURFACE
AND SIDE BURNER
FOR THE PLATINUM SERIES II 3200
(CONTINUED)
Route the side burner hose around the tank panel so it
will not interfere with the scale indicator rod.
The side burner hose is connected in the following
manner:
Slide back the collar of the quick disconnect on the
manifold. Push the male fitting of the side burner hose
into the quick disconnect, and maintain pressure. Slide
the collar closed. Figure 12. Figure 13 shows the quick
disconnect engaged.
Male fitting
Quick disconnect
engaged
Side burner
hose
To NG
supply
Manifold side view
Figure 12
Manifold side view
Figure 13
To side burner
View from right
underside
Figure 14
Check that the side burner is properly assembled.
Windshield
Grate
Figure 15
WARNING: Set the burner ring onto the burner head
with the slots facing up. Rotate the burner ring until
the four lugs on the burner ring are seated in the four
slots on the burner head. Figure 15 (b).
Note: The burner head has a hole in it that fits over the
igniter electrode.
After this assembly, proceed to step "Install Bottom
Rack" on page 12.
9
(c)
Burner
cap
(b)
Lugs
Slots
Burner
head
(a)
Burner
base
Burner
orifice
Burner
ring
Igniter
electrode