Embroidery; Addition Of 272 Mm X 272 Mm Frame; Embroidering Couching Patterns; Preparing For Embroidery Couching - Baby Lock Solaris BLSAU Instruction And Reference Manual

Embroidery

Embroidery
• 75 built-in embroidery patterns have been
added. For details, refer to the Embroidery
Design Guide.
Addition of 272 mm x 272 mm
Frame
The machine has been upgraded to be compatible
with the embroidery frame H 272 mm × W
272 mm (H 10-5/8 inches × W 10-5/8 inches).
For details on how to insert the fabric into the
embroidery frame, refer to "Inserting Fabric into
Embroidery Frame (408mm × 272 mm (approx.
16 inches × 10-5/8 inches))" in the machine's
Instruction and Reference Guide (Embroidery).

Embroidering Couching Patterns

40 couching patterns for embroidering have been
added. For details, refer to the Embroidery Design
Guide.
Couching patterns can be embroidered using yarn.
CAUTION
• When using yarn, we recommend selecting
yarn of weight 4 (MEDIUM
yarn is often referred to as worsted weight, 20
knitted stitches per 10cm, or 9-11 wraps per
inch. The diameter of the yarn is
approximately 2-3 mm (1/12-1/8 inch). If the
yarn is extremely thin or thick, has an unusual
shape (flat or furry), or more than 2 yarns, the
best finishing results may not be achieved, or
injuries or damage may result.
Note
• Before embroidering your project, do trial
embroidery on a scrap piece of fabric that is
the same as that used in your project.
5

■ Preparing for Embroidery Couching

a
b
c
d
e
f
g
• When using embroidery couching foot "Y",
). Medium
h
Turn off the machine.
Attach the embroidery unit.
Install a bobbin wound with embroidery
bobbin thread.
Turn on the machine.
Press .
Select , and then select the desired
pattern from the category.
And then press .
Press to lock all keys and buttons, and
then raise the presser foot lever.
Attach embroidery couching foot "Y".
CAUTION
make sure the machine is in embroidery
mode. Otherwise, the needle will strike the
embroidery couching foot, causing the needle
to break and possibly causing injury.
Rotate the handwheel and check that the
needle is in the left half of the hole in
embroidery couching foot "Y".
If the needle is not in the left half, use the multi-
purpose screwdriver to turn the screw of embroidery
couching foot "Y" to adjust the position of the
embroidery foot. Turn the screw toward you to move
the embroidery foot to the right. Turn the screw toward
the back to move the embroidery foot to the left.
After making adjustments, rotate the handwheel and
check that the needle does not touch the presser foot.