Baby Lock Solaris BLSAU Instruction And Reference Manual page 12

Embroidery
g
When embroidering is finished and the
following message appears, press
 The next part to be embroidered appears.
h
Position each part and embroider it
according to the on-screen instructions.
You will be prompted to align the starting point, rotate
the design, and to rehoop the quilt when necessary.
c
b
a
c
a When embroidering the edge part
Use the move pattern keys to align the start point projected by
the projector with the end point of the previous pattern, and
then press .
Note
• For precise positioning of the start point,
rotate the handwheel toward you to check
the needle drop point. After checking the
needle position, be sure to use the needle
up/down key to return the needle to its
highest position.
11
.
d
a
b
c
b
Rotate the pattern to align the corner with the reference line,
and then press .
b When embroidering the edge part immediately before a
corner
Use the move pattern keys to align the start point projected by
the projector with the end point of the previous pattern, and
then press .
Then, align the lower-left point (inner corner of the next pattern
to be embroidered) with the lower-left corner of the reference
lines. If the pattern is not angled correctly, rotate it. If the length
of the pattern does not match, enlarge or reduce the pattern so
that the lower-left point is at the lower-left corner of the
reference lines.
After making adjustments, press
a
a Inner corner of next pattern to be embroidered
.