Elitegroup Computer Systems 741-M Manual page 65

Resume By Ring (Disabled)
An input signal on the serial Ring Indicator (RI) line (in other words, an incom-
ing call on the modem) awakens the system from a soft off state.
MACPME Power Up Control (Disabled)
Use this item to enable MAC activity to wakeup the system from a power sav-
ing mode.
Resume By PCI PME (Enabled)
This item specifies whether the system will be awakened from power saving
modes when activity or input signal of the specified hardware peripheral or
component is detected.
Power Up by Alarm (Disabled)
When set to Enabled, the following three fields become available: Month
Alarm, Day of Month, and Time Alarm Upon arrival of the alarm time, it will
instruct the system to wake up.
When set to 0 (zero) for the day of the month, the alarm will power on your
system every day at the specified time.
**Reload Global Timer Events**
These fields determine which events waken the system from power saving
mode.
Primary/Secondary IDE (Disabled)
When this item is enabled, the system power will resume the system from a
power saving mode if there is any activity on primary or secondary IDE chan-
nels 0 and 1.
FDD, COM, LPT Port (Disabled)
When this item is enabled, the system will restart the power-saving timeout
counters when any activity is detected on the floppy disk drive, serial ports, or
the parallel port.
PCI PIRQ [A-D]# (Disabled)
When this item is enabled, any activity from one of the listed devices wakes
up the system.
Press <Esc> to return to the Power Management Setup screen.
40