AEG HK764070FB User Manual page 13

Problem
Residual heat indicator does
not come on.
Automatic Heat Up function
does not operate.
You cannot activate the out-
er ring.
There is a dark area on
the multiple zone.
The sensor fields become
hot.
There is no signal when you
touch the panel sensor
fields.
comes on.
comes on.
and a number come on.
7.2 If you cannot find a
solution...
If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre. Give the
data from the rating plate. Give also
three digit letter code for the glass
ceramic (it is in the corner of the glass
Possible cause
The zone is not hot because
it operated only for a short
time.
The zone is hot.
The highest heat setting is
set.
It is normal that there is a
dark area on the multiple
zone.
The cookware is too large or
you put it too near to the
controls.
The signals are deactivated.
Automatic Switch Off oper-
ates.
The Child Safety Device or
the Lock function operates.
There is an error in the hob.
surface) and an error message that
comes on. Make sure, you operated the
hob correctly. If not the servicing by a
service technician or dealer will not be
free of charge, also during the warranty
period. The instructions about the
Service Centre and conditions of
guarantee are in the guarantee booklet.
ENGLISH
Remedy
If the zone operated suffi-
ciently long to be hot, speak
to an Authorised Service
Centre.
Let the zone become suffi-
ciently cool.
The highest heat setting has
the same power as the func-
tion.
Activate the inner ring first.
Put large cookware on the
rear zones if possible.
Activate the signals.
Refer to "Daily use" chapter.
Deactivate the hob and acti-
vate it again.
Refer to "Daily use" chapter.
Disconnect the hob from the
electrical supply for some
time. Disconnect the fuse
from the electrical system of
the house. Connect it again.
If comes on again, speak
to an Authorised Service
Centre.
13