Installation - pro user APR035X2 Manual

INSTALLATION

These instructions do not apply to all vehicles. They are only meant as a general
guide due to the number of different makes & models. For vehicle specific
questions contact your vehicle's manufacturer.
Camera installation
There are several ways to mount the cameras on the back of your vehicle or trailer. But
the most convenient is to mount it near the license plate of the vehicle or trailer.
Supplied are two mounting plates that can be fixed behind the license plate, and the
mounting plates have been installed in the cameras.
The camera is tiltable, camera angle can be adjusted manually on vertical direction. Make
sure that its field of view and detection are not obstructed.
There are two sets of cameras and transmitters, use the same way below to install them
on the vehicle and trailer respectively.
1. Remove the rear license plate, and then loosen the license plate bolts/screws.
2. Position the supplied mounting plate (with camera together) behind the license plate
bracket. Secure both license plate bracket and mounting plates with the license plate
bracket bolts/screws.
3. Mount the license plate on the license plate bracket.
4. Choose a routing path for the camera's power cable through the vehicle's (or trailer's)
body to the reverse light circuit. If in doubt, seek professional installation assistance.
3