Overview; Scope Of Delivery - Metabo BF 18 LTX 90 Original Instructions Manual

Wear protective gloves.
Always wear protective goggles.
Secure the workpiece against slipping, e.g. with
the help of clamping devices.
Always guide the machine with both hands on the
handles provided. Loss of control can cause
personal injury.
Never place your hand near rotating parts of the
device or near the rotating sanding belt.
Remove sanding dust and similar material only
when the machine is not in operation.
Remove the battery pack from the machine before
any adjustments, conversions or servicing are
performed.
Before fitting the battery pack, make sure that the
machine is switched off.
The rated speed of the sanding belt must be at
least equal to the belt speed in idling marked on
the power tool. A sanding belt running faster than
its rated speed can break and fly apart.
Check prior to each use that the sanding belt is
correctly attached and is completely on the rollers.
Carry out a trial run: Allow the machine to run at
idling speed for 30 seconds in a safe location. Stop
immediately if significant vibrations occur or if
other defects are noted. If such a situation occurs,
check the machine to determine the cause.
4.1 Safety instructions for battery packs:
Protect battery packs from water and
moisture!
Do not expose battery packs to naked
flame!
Do not use faulty or deformed battery packs!
Do not open battery packs!
Do not touch or short-circuit battery packs!
Slightly acidic, flammable fluid may leak
from defective Li-ion battery packs!
If battery fluid leaks out and comes into
contact with your skin, rinse immediately
with plenty of water. If battery fluid leaks
out and comes into contact with your eyes, wash
them with clean water and seek medical attention
immediately.

5 Overview

See page 3 (please unfold).
1 Sanding attachment
2 Rotary knob for securing the sanding
attachment and adjusting the belt run
3 Cover
4 Arrow (direction of rotation of drive shaft)
5 Screw for securing the cover
6 Sanding belt
7 Tensioner arm for replacing the sanding belt
8 Sanding head
9 Locking screw for adjusting sanding head
10 Additional handle
11 Sliding on/off switch
12 Electronic signal indicator
13 Battery pack release button
14 Capacity indicator button
15 Capacity and signal indicator
16 Battery pack
17 Dust filter

6 Scope of delivery

The machine is also available with different acces-
sory parts. An overview can be found on page 4.
Subject to change.
A Battery pack
B Sanding belt arm
C Sanding belt, ceramic grain
D Nylon web band
7 Initial Operation
7.1 Attaching the additional handle
Always work with the additional handle
attached (10)! Attach the additional handle
on the left or right of the machine and secure.
Attach the additional handle to the side facing
away from the sanding belt (6).
7.2 Turning the sanding head (8) to operat-
ing position
Loosen the locking screw (9) using the hexagon
spanner and, if necessary and depending on the
task at hand, turn the sanding head (8). The
sanding head must be positioned in the permitted
working area as shown (see illustration A, page 3).
Firmly tighten the locking screw (9).
Each time before you start work, verify that
the locking screw (9) is sufficiently tightened
to ensure that the sanding head (8) does not move.
Otherwise, the sanding belt (6) may come in
DEUTSCH
ENG
11