Sony NW-WM1A Service Manual page 8

NW-WM1A/WM1Z
2-3. Model information check
It can check the settings information.
Be sure to that the correct settings have been performed.
Used folder name (tool):
NWWM1_A30_ModelInfo-V1.00
Procedure:
1. Connect the WALKMAN main unit to PC (personal computer)
by the USB cable (WM-PORT).
(The power supply of the WALKMAN is automatically turned
on)
Note 1: If leave the connection status in the previous step, this step is not
necessary.
– The following steps will all operate on the PC (personal com-
puter) –
2. Check how the WALKMAN is recognized by MSC connec-
tion, and the check of the drive letter is necessary.
(at this example, it is "F:")
3. Open the folder that the model information check tool.
4. In the non-selected state for fi les in the folder, and put a cursor
to blank space in the folder.
In the folder of the model information check tool
5. The right-click while pressing the Shift key in the state of step
4.
6. Select the "Open command window here" from the displayed
menu, and launch the command prompt application software.
7. Input the following command and press the Enter key.
"get_model_info.bat f:"
("f:" is drive letter of checked at step 2)
C:\NWWM1_A30_ModelInfo-V1.00>get_model_info.bat f:
8
USB cable
drive letter
blank space
cursor
Input
8. It will appear the following fi gure results.
(Displayed characters/values in the following fi gure are ex-
ample)
Destination Bundled headphone
code number code number
Body color Model ID
code number code number
9. Check the code number of each items.
Model name Check items
Destination
NW-WM1A
Bundled head-
phones
(not bundled)
Model ID
NAND capacity
(128GB)
Body color
Destination
NW-WM1Z
Bundled head-
phones
(not bundled)
Model ID
NAND capacity
(256GB)
Body color
Note 2: For detail about the Destination column of the above table, refer
to "DESTINATION ABBREVIATIONS" on page 4.
10. Input "exit" and press the Enter key to close the command
prompt application software.
C:\NWWM1_A30_ModelInfo-V1.00>exit
Model information check is complete.
Please proceed to the "2-4. Pre-installed contents settings"
on page 9.
NAND capacity
code number
Code number
AEP : 03 01 00 00
UK : 03 01 00 00
EE : 02 00 00 00
E : 06 00 00 00
AUS : 06 00 00 00
CH : 04 00 00 00
JE : 06 00 00 00
50 48 4f 4e
07 00 00 20
31 32 38 47
00 00 00 00
US : 01 00 00 00
CND : 01 00 00 00
AEP : 03 01 00 00
UK : 03 01 00 00
EE : 02 00 00 00
E : 06 00 00 00
AUS : 06 00 00 00
CH : 04 00 00 00
JE : 06 00 00 00
50 48 4f 4e
08 00 00 21
32 35 36 47
00 00 00 00
Input