Sony NW-WM1A Service Manual page 47

5-16-4. Reboot (test mode release)
(Reboot (normal))
It can be the reboot, releasing the test mode status.
Procedure:
1. Enter the test mode.
(Refer to "2. SETTING THE TEST MODE" on page 33)
2. Press the [+]/[–] keys to select the "Shutdown", and press the
[ ] or [ ] key to enter the minor item.
u >
3. Press the [+]/[–] keys to select the "Reboot (normal)".
4. Press the [ ] key, the execution screen is displayed.
u
Screen display
Reboot
(SHT RENR command)
Reboot?
(exit diag)
push PLAY key
5. Press the [ ] key, then start the reboot.
u
(After the reboot, to start up on normal mode status)
5-17. Log (Log)
Screen display
Diagnosis APP
[ver X.XX.XX]
Initialize log
Show log
Copy log
5-17-1. Initialize log data (Initialize log)
It can be initialized log data recorded to NVP.
Procedure:
1. Enter the test mode.
(Refer to "2. SETTING THE TEST MODE" on page 33)
2. Press the [+]/[–] keys to select the "Log", and press the [
or [ ] key to enter the minor item.
>
3. Press the [+]/[–] keys to select the "Initialize log".
4. Press the [ ] key, the execution screen is displayed.
u
Screen display
Log initialize
(LOG INIT command)
initialize OK?
5. Press the [ ] key, perform the initialization of the log data.
u
6. Slide the [HOLD] switch in the direction of on, to return to
minor item selection screen.
5-17-2. Add log data (Add log)
Note: Not used for the servicing.
5-17-3. Show log data (Show log)
Note: Not used for the servicing.
NW-WM1A/WM1Z
Log
Add log
]
u
47