2-21. STRAP HOLDER ASSY, CARD LID ASSY
Note: Start removing from either the strap holder assy or card lid assy.
top side
front side
3 Open the card lid.
4 screw (NDS-EL)
(M1.4
3)
2-22. HINGE STOPPER, ESCUTCHEON (MULTI), KEY-LED FPC ASSY (FPC2)
3 escutcheon (multi)
Note: When installing the escutcheon
(multi), align the rib and hole.
1 screw (NDS-EL)
(M1.4
3)
2 strap holder assy
bottom side
bottom side
1 screw (SG)
rib
bottom side
hole
SD card mark
card lid assy block
5 Remove the card
lid assy block.
(M1.4)
2 hinge stopper
front side
NW-WM1A/WM1Z
rear side
bottom
strap holder
front side
assy
7 escutcheon
(card)
6 Draw the card lid assy
shaft out of the hole.
8 card lid assy
4 three screws (SG)
(M1.4)
5 KEY-LED FPC assy
(FPC2)
top side
31