Huawei EchoLife HG8240 Service Manual page 32

5 Web Page Reference
2.
Table 5-4
Table 5-4 Basic Wi-Fi parameters
Parameter
Enable Wireless
SSID
Associated Device
Number
Broadcast Ssid
WMM Enable
Authentication Mode
5-16
Click Apply to apply the configuration.
describes the basic Wi-Fi parameters.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
EchoLife HG8240/HG8245/HG8247 GPON Terminal
Description
Indicates whether to enable the wireless network. The following
parameters can be set only when the wireless network is enabled.
Indicates the name of the wireless network. It is used to
differentiate different wireless networks. It consists of a
maximum of 32 characters, without space or Tab character.A
default SSID1, named WirelessNet is created after the creation
of an ONT. The system can configure up to four SSIDs at a time
and cannot assign IP addresses to Wi-Fi terminals by SSID.
Specifies the number of STAs. It ranges from 1 to 32.
Indicates whether to enable or hide broadcast.
l If the option box is selected, it indicates that the SSID
broadcast function is enabled. The ONT periodically
broadcasts the SSID, that is, the name of the wireless
network. In this way, any STA can search for the wireless
network.
l If the option box is not selected, it indicates that the SSID
broadcast function is disabled. The SSID is hidden, and the
STA cannot search for the wireless network. The SSID can
be obtained only through a request.
Indicates whether to enable the QoS of the wireless network.
After the function is enabled, the video and voice QoS can be
improved.
Indicates the authentication mode for the STA to request access
to the wireless network. The mode can be Open, Shared, WPA
Pre-Shared Key, WPA2 Pre-Shared Key, WPA Enterprise,
WPA2 Enterprise, or Wi-Fi Protected Setup.
It is set to open by default, that is, the STA can access the network
without authentication.
Service Manual
Issue 04 (2011-01-12)