Kogan KAGWAS10D6A User Manual page 11

Drain hose connection
1. Directly into a sink
If the outlet spigot has not been used before, remove any blanking plug that may be in
place.
Push the drain hose onto the spigot and secure with a clip if required, ensure a loop is
formed in the drain hose to prevent waste from the sink entering the washer-dryer.
If required, the drain hose can be extended to a length of 4 m.
Loop
2. Connected securely to a standpipe
Firstly, form a hook in the end of the drain hose using the plastic "U" piece supplied.
Place the drain hose into your standpipe, which should have an internal diameter of
approximately 30mm, thus ensuring there is an air brake between the drain hose and
standpipe.
When discharging into a standpipe, ensure that the top of the standpipe is no more than
90cm and no less than 60cm above floor level.
"U" piece
supplied