Duramaxx 10029765 User Manual page 35

Solar Power Pack Connection:
If you have an additional solar power pack: Plug the Solar pack controller cable to the Solar
PW port on the main unit. Touch the PW button on the controller to start up the storage power
to the camera. The solar power pack will always supply energy in 24 hours and will be charged
under sun light. It isn't a matter there are some days with cloudy because a high capacity stor-
age power pack will support this camera to work for a few days or a thousand shots after one
time of fully charged. This camera is only supported by the Solar model SO6-9V.
Power Management:
It is highly recommended to install 6 pcs Alkaline batteries into the camera compartment even
though you prefer to always use a solar system. The back up battery dose stand by while the
solar pack energy still be enough to support Camera operation as usual. It will be drained only
since the power pack goes to the OFF w/o any charging for a long time. It is ideal for remaining
the scouting settings even no more supply from Solar pack.
CONNECT an external Infra-Red Booster
For an experienced user, you always would expect to get extreme quality pictures and videos
at night. This Cam does provide a solution that a wireless booster like IRX-22BW will enhance
the camera simply. Thus, camera will get several times higher illumination depend on a number
of boosters to be configured. Refer to the user guide and snap the transmitter to the belt or
Python easily. Set the IR trigger Sensor against the IR light source on the camera.
Just need a single transmitter to control unlimited wireless boosters which they will be set with
a same frequency work group around 100 feet.
Use lens hood
This lens hood is come with the packing that is used for installing on the camera lens to
prevent sun light reflection too much into the camera sensor and snow or rain as well as
snow-fall stacked in front of the lens.
35