Duramaxx 10029765 User Manual page 23

SELF-TEST light goes OFF after 1 minute, try to walk in front of motion sensor in order to
verify how much distance and a zone you will be detected according to the flashing walk-
test light .
• Push PW back to ON and leave. Now the scouting camera will ready to work after 10 sec-
onds of warm-up time.
Factory default settings
Camera: Capture = Single Picture / Auto Exposure / 3M pixels resolution / Burst Mode = Off /
Shutter Speed = Auto / Quality = Normal / Stamp = ON / Language = English / TV = NTSC /
Download = MSDC / Video Resolution = VGA 640x480 / Frame rate = 15 F/S
Motion detection: Pause = 1 minute / Quick-Shot = 1 / Turbo = PW-Save / Work Duty = 24 HRs
/ 3 seconds Video length
It is suggested to customize your settings if you are an experience user.
Switch the PW ON, the lower LCD show the default settings immediately. After 20~30s, it's
back light goes to OFF and now you can able to program with your desired parameters instead
of the system default for both camera and motion detector operation. When the unit exit from
setting mode or no change since PW ON, it will goes to the motion detection ON Duty mode
automatically after 1 minute.
Start up with User's Setting
23