Mode Selection; Equalizer Function - Ryobi R18RH Original Instructions Manual

replace the AAA batteries.
NOTE: When the product is on and a battery pack is
installed, will be shown in the LCD display. If the battery
charge is low, a fl ashing will be displayed.
To help preserve battery power, the product will
automatically enter sleep mode approximately 1 hour after
it is turned off. To exit sleep mode and restart the product,
you must press on the product.

MODE SELECTION

See figure 3.
■ Press to cycle through available modes.
There are four modes to choose from:
■ FM mode
■ AM mode
■ AUX mode
■ BLUETOOTH mode
ADJUSTING THE VOLUME
See figure 3.
When the product is switched on, the product will return to
the last volume setting used.
NOTE: If the AAA batteries are removed from the product
or have no charge, the volume will return to its default
settings.
■ To increase the volume, press
■ To decrease the volume, press
NOTE: To change volume quickly, hold
CAUTION
Do not use the product at maximum volume for an
extended period of time with the bass and treble at
maximum levels. It could cause damage to the speakers
and/or amplifi ers in the product.
FM/AM TUNING
See figure 3.
Use and to tune to the desired radio frequency. The
selected frequency is displayed on the LCD display.
To tune frequency manually:
Briefl y push either or
one frequency step at a time.
1. Press and release to tune to a lower frequency.
2. Press and release to tune to a higher frequency.
4 | English
.
.
or .
(not press and hold) to tune
To tune frequency automatically:
1. Press and hold or
frequency automatically.
2. Press or to stop scanning and select a frequency.
To decrease interference or electrical noise, adjust the
position of the FM receptor or move the product to a higher
elevation.
STORING A PRESET IN MEMORY
See figure 3.
The memory feature saves up to 20 frequencies as
presets in the product's memory. You can save up to 10
frequencies each for FM and AM modes.
To store a frequency in memory:
1. Tune to the desired FM or AM frequency.
2. Press and hold
preset position number flash on the screen.
3. Press and to choose a preset position number.
NOTE: There are 10 preset positions for FM and 10
for AM. Only one station can be saved in each preset
position.
4. Press again to store the frequency.
To tune to presets (FM or AM mode):
■ Press and release
preset position number and its associated frequency.

EQUALIZER FUNCTION

To adjust the bass and/or treble settings:
1. Press and hold
Press again and "t" (TREBLE) is displayed.
2. Press or until the desired bass or treble level
(–5 to 5) is achieved . Press
selection.
SETTING THE CLOCK
See figure 3.
Press to view the frequency in the digital display
for 10 seconds. The display will return to the current time
after 10 seconds.
NOTE: In all modes, the time is the default display.
To set the clock:
1. Press and hold
2. Press or to select the hour.
3. Press and release
Minute time blinks.
for one second to tune
until "MEMORY" and the
to cycle through each
until "b" (BASS) is displayed.
to store your
until the hour time blinks.
to lock in the hour setting.