NewAir NWC007SS00 Owner's Manual page 9

provides the best performance and also prevents overloading house wiring
circuits that could be a fire hazard from overheating. Never unplug the
appliance by pulling the power cord. Always grip the plug firmly and pull
straight out from the receptacle. Repair or replace immediately all power cords
that have become frayed or otherwise damaged. Do not use a cord that shows
cracks or abrasion damage along its length or at either end. When moving the
appliance, be careful not to damage the power cord.
EXTENSION CORD
Because of potential safety hazards under certain conditions, it is strongly
recommended that you do not use an extension cord with this appliance.
However, if you must use an extension cord it is absolutely necessary that it be
a UL/CUL-Listed, 3-wire grounding type appliance extension cord having a
grounding type plug and outlet and that the electrical rating of the cord be 115
volts and at least 10 amperes.
INSTALLATION OF YOUR APPLIANCE
•
This appliance is designed for built-in (fully recessed) installation.
•
Place your appliance on a floor that is strong enough to support it when it
is fully loaded. To level your appliance, adjust the front leveling legs at the
bottom of the appliance.
•
Locate the appliance away from direct sunlight and sources of heat (stove,
heater, radiator, etc.). Direct sunlight may affect the acrylic coating and
heat sources may increase electrical consumption. Extremely cold ambient
temperatures may also cause the unit not to perform properly.
•
Avoid locating the unit in moist areas.
•
Plug the appliance into an exclusive, properly installed-grounded wall
outlet. Do not under any circumstances cut or remove the third (ground)
prong from the power cord. Any questions concerning power and/or
grounding should be directed toward a certified electrician or a service
center authorized by Felix Storch, Inc.
9
newair.com