Installation Place Requirements - LG RC81V5AV0Q Owner's Manual

EN 10 INSTALLATION
Specifications
Asterisk(s) means model variant and can be varied (0-9) or (A-Z).
Power supply
Dimension (Width X Depth X Height)
Product weight
Allowable temperature
Installation Place
Requirements
Before installing the appliance, check the
following information to make sure that
the appliance should be installed in a
correct place.
Installation Location
WARNING
• Do not install the appliance around a
heat source. The rear side of the
appliance must be well ventilated.
Failure to follow these instructions
may result in problems.
• The appliance is not designed for
maritime use or for use in mobile
installation such as caravans, aircraft
and etc.
• Do not install the appliance as a built-
in appliance. It is not suitable for built-
in purpose.
NOTE
• For better drying performance, keep
the rear of the appliance away from
the wall.
Model RC*1V5AV*Q
220 - 240 V~, 50 Hz
600 mm X 690 mm X 850 mm
56 kg
5 - 35 ℃
• Make sure that the location where the
appliance will be installed meets a
minimum clearance conditions.
• Install the appliance on a flat hard
floor. Allowable slope under the
appliance is 1 degree.
• Never try to correct any unevenness in
the floor with pieces of wood,
cardboard or similar materials under
the appliance.
• Install the appliance in a location
where service engineers are easily
accessible in the event of a breakdown.
• Do not install the appliance next to
high-temperature appliances such as
refrigerator, oven or stove, and etc. It
can cause poor drying performance
and delay programme duration. It also
adversely affect the proper functioning
of the compressor.
• Do not install the appliance where
there is a risk of frost or dust. The
appliance may not be able to operate
properly or may be damaged by
freezing of condensed water in the
pump and drain hose.
• With the appliance installed, adjust all
four feet using a spanner to ensure the
appliance is stable, and a clearance of
approximately 20 mm is left between