PI E-4 Series Short Instructions

Housed analog piezo electronics

Advertisement

PZ300EK 1.0.0 08/2020. 1.0
Housed Analog Piezo Electronics
Short Instructions
E-4xx, E-5xx, E-6xx, E-8xx
User Information
These short instructions contain an overview of the most important safety information and hand-
ling instructions for installing, starting and operating analog piezo electronics (hereinafter referred
to as electronics) with the above-mentioned product numbers (x: any number).
Subject to change. These short instructions are superseded by any new release. The latest respecti-
ve release is available for download on our website.
Downloading and Reading the Manual
The actions during installation, starting and operating, adapting the settings, and maintenance
require additional information from the manuals for the electronics and/or the positioner.
Manuals may be titled as follows: „User Manual", „Technical Note".
Downloading the manuals and the software from the website
If you received a CD from PI with the PI Software Suite, follow the instructions in the Manuals/
A000T0081-Downloading Manuals from PI.pdf file on the CD.
If the product was supplied without CD:
1. Open the website www.pi.ws.
2. Search the website for the product number (e.g., C-663.12) or the product family (e.g., PICMA®
Bender).
3. Click the corresponding product to open the product detail page.
4. Click Downloads.
The manuals are displayed under Documentation.
5. Click the desired manual and fill out the inquiry form.
The download link will then be sent to the email address entered.
If you cannot find the manual you are looking for or if you have any questions: Contact our custo-
mer service department via service@pi.de.
Physik Instrumente (PI) GmbH & Co. KG, Auf der Roemerstr. 1, 76228 Karlsruhe, Germany
Phone +49 721 4846-0, Fax +49 721 4846-1019, Email info@pi.ws, www.pi.ws
M O T I O N | P O S I T I O N I N G

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the E-4 Series and is the answer not in the manual?

Questions and answers

Summary of Contents for PI E-4 Series

  • Page 1 Manuals may be titled as follows: „User Manual“, „Technical Note“. Downloading the manuals and the software from the website If you received a CD from PI with the PI Software Suite, follow the instructions in the Manuals/ A000T0081-Downloading Manuals from PI.pdf file on the CD.
  • Page 2: General Safety Information

    PI. Use original PI parts only. The electronics may only be used in compliance High temperatures can cause the electronics to with the technical specifications and instruc- overheat.
  • Page 3 PZ300EK 1.0.0 08/2020. 1.0 Connecting the Electronics to the Power Securing the Electronics Supply When the electronics are to be used as a bench- top device: NOTICE Make sure that the electronics are standing safely and securely. Electronics with integrated power ad- If the electronics are to be mounted: apter are factory set to the line voltage 1.
  • Page 4: Starting And Operating

    Positioner with compatible drive type ▪ 5. If the Overflow LED for the channel lights If necessary: Suitable adapter from PI up, adjust the sensor‘s zero point with the ▪ If necessary: Suitable extension cable from ZERO potentiometer until the Overflow LED extinguishes.
  • Page 5: Old Equipment Disposal

    13 August 2005. in EU member states via the municipal residual If you have an old device from PI, you can send waste. it to PI free of charge.

This manual is also suitable for:

E-5 seriesE-6 seriesE-8 series

Table of Contents