® In case of doubt the Harken Tech Service is at your disposal at techservice@harken.it This Manual is available only in English. If you do not fully understand the English language, do not carry out the operations described in this Manual.
It is the installer's responsibility to carry out all structural tests needed to ensure that the deck can ® bear the load. Harken does not supply the screws needed to install the winch since these may vary depending on the deck on which it is to be installed.
Page 5
The winch can be installed following one of the two procedures below (Procedure1 or Procedure 2): Procedure 1 To install the winch you must remove the drum and use Socket Head (SH) bolts. Tools needed One medium flat-bladed screwdriver To identify the various parts, refer to the exploded view at the end of this Manual. Torque to apply when assembling 1.
Page 6
Procedure 2 To install, you must remove the winch skirt and use hexagonal headed bolts. Tools needed One medium flat-bladed screwdriver To identify the various parts, refer to the exploded view at the end of this Manual. 1. Remove the skirt n°2 with the help of 2.
Page 7
A. Position the base of the winch on the deck and mark the position of the holes or use the drilling cut-out template at the point where you have decided to place the winch. Below is a reduced scale diagram. The drilling cut out template is available on the Harken® website, www.harken.com 60° final pinion position Ø6.2...
C. Bolt the base of the winch to the deck using five M6 Socket Head (SH) bolts for Procedure 1 or five ® hexagonal headed M6 bolts for Procedure 2 (neither is supplied by Harken ), correctly chosen for the thickness and type of the boat deck. Consult the yard that built the boat in case of doubt.
Page 9
Installation and maintenance of winches must be carried out exclusively by specialized personnel. ® In the case of doubt contact Harken Tech Service at techservice@harken.it Disassembly procedure Tools needed...
Page 10
7. Slide off gear n°3 8. Slide off gear n°11 9. Unscrew the screw n°10 and remove the washer n°9 ( 4Nm/35 in-lb) Once the winch is completely disassembled, clean the parts: use a basin of diesel oil to soak metal components and rinse plastic parts in fresh water.
Page 11
Exploded view with maintenance products Anti-seize Harken ® Grease Harken ® Pawl Oil ® Loctite Apply Harken grease on assy socket screw ® Apply Harken ® grease on drum gear 20.2 PTP Installation and Maintenance Manual Performa Winch ™...
Once in position, check that the pawls can be easily opened and closed with a finger. ® In case of doubt concerning the assembly procedure contact Harken Tech Service: techservice@harken.it ® Harken limited worldwide warranty ®...
Page 13
Manufacturer Harken Italy S.p.A. ® Tech Service Via Marco Biagi, 14 Email: techservice@harken.it 22070 Limido Comasco (CO) Italy Tel: (+39) 031.3523511 Customer Service Fax: (+39) 031.3520031 Tel: (+39) 031.3523511 Email: info@harken.it Email: info@harken.it Web: www.harken.com Headquarters Harken , Inc. ®...