Table of Contents
Advertisement
GETTING STARTED
Connect Telephone Line Cord
Plug one end of the telephone cord into
a wall jack and the other end into the
back of the base unit.
Check for a dial tone. After the battery
pack is charged, put on the headset
and flip the microphone down into the
ON position.
You should hear dial
tone.
If not, see IN CASE OF DIFFICULTY.
Fill in the telephone number card on
the remote charging stand.
CAUTION :
1. Never install telephone wiring
during a lightning storm.
2. Never install telephone jacks in
wet locations unless the jack is
specifically designed for wet
locations.
3. Never touch uninsulated telephone
wires or terminals unless the
telephone
disconnected at the network
interface.
4. Use caution when installing or
modifying telephone lines.
13
line
has
been
Advertisement
Table of Contents
