Busch-Jaeger WaveLINE 6701 Manual page 38

Disconnecting and resetting
devices
4 After successful programming,
the LED starts to flash red again.
If the deleting procedure is not
successful (the LED continues to
light up), reset the selector switch
on the Busch Watchdog to "P"
and repeat the procedure.
5 The devices are disconnected
from each other.
6 Set the operating mode to "R" or
"S" on the receiver and to "GS" or
"ES" on the transmitter. The
remaining devices are again
ready for operation.
ENG 38