Busch-Jaeger WaveLINE 6701 Manual page 36

Programming devices
4 After successful programming,
the LED starts to flash green
again. If programming is not
successful (the LED continues to
light up), reset the selector switch
on the Busch Watchdog to "P"
and repeat the procedure.
5 This programs the devices to
each other.
6 Set the operating mode to "ES" or
"GS".
7 Set the operating mode to "R" or
"S" on the receiver. The devices
are ready for operation or
additional devices can be
programmed (up to max. 48
units).
ENG 36