Table of Contents
Advertisement
GETTING STARTED
5.
Press the OK key to display the
current DIAL TYPE setting and
allow editing of the DIAL TYPE
parameter:
6.
Use the
/
between Tone and Pulse.
7.
Press the OK key to confirm your
selection. A confirmation tone will
be generated, and the screen will
display:
8. Press OFF twice to exit SETUP
MODE.
Connect Telephone Line Cord
Plug one end of the telephone cord into
a wall jack and the other end into the
back of the base unit.
If the VT 1421 does not detect that an
active telephone line cord is connected,
the following message will be displayed:
keys to toggle
12
Check for a dial tone. After the battery
pack is charged, pick up the handset
and press PHONE, you should see the
following display:
If not, see IN CASE OF DIFFICULTY.
Fill in the telephone number card on
the base unit.
CAUTION:
1.
Never install telephone wiring
during a lightning storm.
2.
Never install telephone jacks in
wet locations unless the jack is
specifically designed for wet
locations.
3.
Never
touch
telephone
wires or terminals
unless the telephone lane has
been disconnected at the network
interface.
4.
Use caution when installing or
modifying telephone lines.
uninsulated
Advertisement
Table of Contents
